Stego, Inc
Stego, Inc.
95 Chastain Road NW
Suite 200
Kennesaw, GA 30144, USA
Toll-Free: (888) 783-4611 • Phone: (770) 984-0858
Email: info@stegousa.com • Website: www.stego-usa.com
Print Back
  • Cable gland with integrated ventilation
  • High degree of protection
  • Easy to install
  • Integrated strain relief
  • Waterproof filter
  • Large clamping range


    • Pressure differentials in enclosures with a high degree of protection are a result of internal and external temperature changes. In the case of negative pressure or partial vacuum, dust and humidity can enter the enclosure through the door seal. When the air inside the enclosure cools down, condensation may occur because the humidity cannot escape the enclosure. The innovative and easy-to-install ventilation cable gland DAK 284 enables secure cable entry into an enclosure with simultaneous pressure compensation (protection type IP66 / IP67). Even with a slight overpressure, a waterproof filter inside the gland allows the humidity to escape whilst blocking water and dirt from entering the enclosure.
    Unit of Measure

    Specifications

    Thread Size M

    		 N/A M16 x 1.5

    Thread Length L

    		 N/A 0.39 inches (10 mm)

    External Thread Diameter

    		 N/A 0.64 inches (16.3 mm)

    Cable Dia. Clamping Range D

    		 N/A 0.16 - 0.32 inches (4 - 8 mm)

    Hex Nut Dia. SW 1

    		 N/A 0.74 inches (19 mm)

    Hex Nut Dia. SW 2

    		 N/A 0.86 inches (22 mm)

    Torque Lock Nut

    		 N/A 2 Nm

    Torque Dome Nut

    		 N/A 2 Nm
    Air Permeability1 N/A 25 l/h

    Weight

    		 N/A 0.28 oz. (8 g)

    Technical Data

    Mounting

    		 N/A thread M12 x 1.5 / M16 x 1.5 / M20 x 1.5

    Enclosure Wall Thickness

    		 N/A 0.02 - 0.12" (0.5 - 3 mm) with lock nut

    Material

    		 N/A plastic, light grey

    Protection Type

    		 N/A IP66 / IP67 (EN 60529)

    Sealing

    		 N/A sealing gasket NBR

    Filter

    		 N/A PTFE

    Fitting Position

    		 N/A variable

    Operating/Storage Temperature

    		 N/A -4 to +176 °F (-20 to +80 °C)

    Approvals

    		 N/A UL File No. E471430, VDE and EAC submitted

    Installation

    		 N/A Make hole cut-out in enclosure and secure ventilation cable gland with lock nut. Please make sure that the sealing gasket is put in place on the exterior side panel of the enclosure and the hole is free of burrs.
    • 1 at a pressure differential of 70 mbar (1psi)